jackso11 Posted December 26, 2009 Share Posted December 26, 2009 Trying to fit a boost guage and can't get the heater ball apart! Got the ball out and in my hand but how do you get into it? Quote Link to comment Share on other sites More sharing options...
Scott Posted December 26, 2009 Share Posted December 26, 2009 There are 3 clips holding it in place bud. You aren't trying it in the dark are you? You need a screwdriver to lever them back 1 at a time, pull each one out as you do it so that it doesn't click back into place. Once you have the ball out there are 3 clips holding the ball together iirc. Same idea. Quote Link to comment Share on other sites More sharing options...
jackso11 Posted December 26, 2009 Author Share Posted December 26, 2009 do guages usually fit in from the front or does the front section of the ball go over the guage? Seems I need to go in fron the front but then the guage sticks out about 1cm. Got the ball apart thanks Quote Link to comment Share on other sites More sharing options...
Scott Posted December 26, 2009 Share Posted December 26, 2009 My gauge went in front the front. Once the ball was halfed in 2 and the innards removed, the gauge goes in and then you put the stay bracket in from behind. Only stuck out about 3mm which is the thickness of the rim. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.