barneybrendan Posted October 3, 2009 Share Posted October 3, 2009 if i were to make a block that fits where the filter housing is with two adapters coming off,would that work.thinking alloy block drilled out for the hollow retaing bolt,then two holes drilled from the side into the centre hole.any body got ideas on this. Quote Link to comment Share on other sites More sharing options...
Ark Posted October 3, 2009 Share Posted October 3, 2009 What are you trying to achieve? There are lots of adapter plates readily available for purchase. Quote Link to comment Share on other sites More sharing options...
Nic Posted October 3, 2009 Share Posted October 3, 2009 GReddy Sensor Adapter http://www.trust-power.com/03electric/img/sensor_atach.jpg Quote Link to comment Share on other sites More sharing options...
barneybrendan Posted October 3, 2009 Author Share Posted October 3, 2009 basicly the original housing can not be used anymore as i have no room for it .if the one nic has just shown fits directly to the block then thats what i need.i only have a fiew inches clearance from the block now.but if its something i can make then there would be no need to buy one. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.