need a t3 manifold for a hks gt3037 single turbo

[sidewaysdan]

i need a new manifold for my supra it has a hks gt3037-pro single turbo.does any 1 know where i can get a manifold withe a t3 flange.

[rxv8]

cant you weld the one you have...i presume its cracked...

[sidewaysdan]

cant you weld the one you have...i presume its cracked...

no its a custom manifold. they have used the tt-manifold and welded some more pipe to make it a single.but its restricting the flow so it give mass torque but will max out at about 550/600 bhp

[rxv8]

ok but the 3037s turbo according to specs will only flow 500 ish hp???i had one on my skyline,awesome turbo good power but wont do 550-600...you can get t3 t4 adapters from ebay...
HKS GT3037 Pro S - 480 PS Output

[sidewaysdan]

ok but the 3037s turbo according to specs will only flow 500 ish hp???i had one on my skyline,awesome turbo good power but wont do 550-600...you can get t3 t4 adapters from ebay...

but if i put a t3t4 adapter i will have to change the downpipe.
i had it on the dyno and it put out 490 bhp with 630 nm/of torque at the fly at 1.2bar but with a bad map on ecu so i have a power fc to go in it and my mapper rec it will run 1.6bar and the turbo will take it.

[rxv8]

thats only my advice bud,if your mapper thinks he will get 600hp at 1.6 bar,out of a turbo that should flow 500,thats one goooood mapper...what ecu is on there now and who is mapping...

[sidewaysdan]

thats only my advice bud,if your mapper thinks he will get 600hp at 1.6 bar,out of a turbo that should flow 500,thats one goooood mapper...what ecu is on there now and who is mapping...

it has a hks f-con v-pro on at min.but not alott of peeps map and cost the earth to