Hole in bulk head

In the engine bay, were abouts on a N/A supra does the wire loom go through in to the dash I cannot seam to see it.

On the gto it was at top drivers side same on my soarer but not on the supra.

I have some gauges I want to install and dont really want to drill new holes in the bulk head was hoping to run the wires through the existing hole is.

many thanks

dann

Through the big rubber bellow below the charcoal canister, passenger side top corner on a RHD car.

Thank you very much runs out to have a look.

I could've sworn I did mine somewhere near the pedals. I think it was a rubber bung with nothing going through it until I made a hole in it. Was that a bad idea? Might have been nicer to use the existing loom's bung I suppose.

I could've sworn I did mine somewhere near the pedals. I think it was a rubber bung with nothing going through it until I made a hole in it. Was that a bad idea? Might have been nicer to use the existing loom's bung I suppose.

yes there is one there, but only on autos, the cylinder for the clutch goes through that hole on manuals

The engine's loom runs through the grommit up on the bulkhead on the passenger side, there are some other little bits of loom that run through a grommit on the drivers side as well.