PDA

View Full Version : Techtom MDM100


Gaz Walker
10-11-03, 21:50
Cool gadget

http://www.envyperformance.com/images/products/electronics/big/techtom.jpg

The Techtom MDM-100 Multi-Display Monitor enables the driver to view a number of engine/sensor parameters in real time via the ECU. The MDM-100 allows viewing of two parameters simultaneously and is a view-only proposition that does not adjust the ECU.

Can displays the following...

INJ Injector Duty Cycle ms
DUTY Injector Duty %
IGT Ignition Timing deg
RPM Engine RPM rpm
SPD Speed km/h
WTMP Water Temperature C
THP Throttle Position Sensor Deg
ISCs Idle Speed Control Valve Step
ISCd Idle Speed Control Valve %
PIMt Manifold Pressure kPa
PIMn Manifold Pressure kPa
AFMv Air Flow Meter-Flap V
AFMg Air Flow Meter-Hotwire g/s
AFMk Air Flow Meter-Karman ms
STA-up Startup Fuel Enrichment ON . OFF
WARM-up Warm up Fuel Enrichment ON . OFF
A/F - L Open Loop / Close Loop ON . OFF
A/F - R Open Loop / Close Loop ON . OFF
KNOCK Knock Control ON . OFF
STA-SW Starter Switch ON . OFF
IDL-SW Idle Switch ON . OFF
A/C-SW Air Condition Switch ON . OFF
NTL-SW Neutral Switch ON . OFF
O2-L Oxygen Sensor RICH . LEAN
O2-R Oxygen Sensor RICH . LEAN
DIAG Diagnostic Code OK . NG

The production has recently finished on these but I'm sure they are still available to buy.

A different model is required for VVTi models.

The cost is £395.

Gaz.

Timwildman
10-11-03, 21:52
You been reading my old thread? Cos i want one.

Timwildman
10-11-03, 21:56
http://www.mkivsupra.net/vbb/showthread.php?s=&threadid=13254&highlight=ecu+display

Gaz Walker
10-11-03, 21:57
Just remember seeing it Tim - another customer is after one so I thought I'd post up the details. Took ages to find a decent photo!

Gaz.

Timwildman
10-11-03, 21:59
Does this mean you can get them, because technosquare didn't get back to me. I would need the MDM-100T2 I think for OBDII?

Gaz Walker
10-11-03, 22:04
Originally posted by Timwildman
Does this mean you can get them, because technosquare didn't get back to me. I would need the MDM-100T2 I think for OBDII?

Yup.

T1 for non-VVTi
T2 for VVTi

Gaz.

Thorin
10-11-03, 22:12
Damn it, I want one too.



That's it, I'm selling my soul.

Gaz Walker
10-11-03, 22:16
lol, we try our best Thorin

Gaz.

PS did I mention we take all credit cards? ;)

Thorin
10-11-03, 22:33
Did I mention I make good cups of coffee and I'm looking for a new job? :innocent: