karmen/hotwire

Hi all, upon starting to fit the E-manage blue to the supra, i am confused which colour wires to use. Mine is OBD1 so karmen sensor.

It says to cut ecu wire number 66 and connect Green to ecu and White away from ecu.

Do i still use these two wire colours as i had to use different with the safc????

Desperately need this help if someone can.

I know on my ec u its not number 66 wire as mine is map and diagram is for maf.

I think you will find its referring to a TT ECU, unfortunately i am not failure with the N/A ECU pin outs.

Yeah it is reffering to a tt ecu. Does anyone know where i can see a copy of what pin outs a tt ecu has and an na ecu has, then i can just match what each pin is for and adapt from there.

As the walkthrough is showing for the ignition harness to cut wires 52,53,54,55,56,57 but mine does not evenhave these pins.

Is this correct please:

E.g.

Number 20 pinout on tt ecu is injector 1

Number 25 pinout on the N/A ecu is injector 1

Do i just adapt the tt walkthrough with the numbers and that should be them in the right place???

I think it is.

Can someone help again please.

On the TT ecu pins 52 - 57 are IGT 1, IGT2, IGT3, IGT4, IGT5, IGT6.

On the N/A ecu there is only one IGT on pin 57??????

So where do the 6 wires from the e-manage go on the na ecu, all of them to pin 57??? doubt it.............

Really stuck in a rut here and i really need to finish wiring this in tonight if someone would help me that would be a god send!!