Ady Posted October 1, 2007 Share Posted October 1, 2007 Has any one done this them selves? I seen a few ''carbon fiber'' ones, but im wanting to spray mine blue - to match the SAMCO hose colour - Il collecting alot of 'blue' bits for the engine bay. Dose anyone know if it heats up like the engine block dose? Shown it here - i HATE that discusting green colour Quote Link to comment Share on other sites More sharing options...
tooquicktostop Posted October 1, 2007 Share Posted October 1, 2007 I did mine, stripped it first with Nitromorse then sanded slightly, primer, paint the laquer, not a bad job in the end, key is take your time and allow to fully dry before adding next coat Quote Link to comment Share on other sites More sharing options...
Ady Posted October 1, 2007 Author Share Posted October 1, 2007 I did mine, stripped it first with Nitromorse then sanded slightly, primer, paint the laquer, not a bad job in the end, key is take your time and allow to fully dry before adding next coat Do you need the paint that is heat resistant? or is it ok to use normal spray paint? I have an idea to try too, im going to make a SUPRA stencil , and spray it on in chrome or silver under the toyota badge, would be a nice little feature. What did you use to sand it? sand paper or fine wire wool? Quote Link to comment Share on other sites More sharing options...
Marco Posted October 1, 2007 Share Posted October 1, 2007 http://www.mkivsupra.net/vbb/showthread.php?t=112713 http://www.mkivsupra.net/vbb/showthread.php?t=104486 http://www.mkivsupra.net/vbb/showthread.php?t=64064 .... Quote Link to comment Share on other sites More sharing options...
Ady Posted October 1, 2007 Author Share Posted October 1, 2007 Thanks Marco Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.