JustGav Posted September 15, 2007 Share Posted September 15, 2007 I posted up a while back regarding the PLX gauges. Was looking into a few bits for the 200sx and came across this. http://shop.edoperformance.co.uk/plx-airfuel-ratio-sensor-module-black-52mm-gauge-p-9168.html?osCsid=ce93125b0f77d73196db6208f4ac3bfb Very similar to AEM in that it can output a narrow band signal, and it comes with a Bosch LSU 4.2 sensor so accuracy SHOULDN'T be too bad. I'm tempted to get one and wire it up in parallel with my Innovate LM-1 to check it's accuracy. http://www.plxdevices.com/products/dm100/smafrcombo/dm100smafr.jpg Quote Link to comment Share on other sites More sharing options...
Suprash Posted September 15, 2007 Share Posted September 15, 2007 Is this cheap Gav for a wide band ? If so and accuracy is good then I will purchase, if you wanted to run it first to confirm accuracy then I dont mind..... Quote Link to comment Share on other sites More sharing options...
Thorin Posted September 15, 2007 Share Posted September 15, 2007 The innovate one uses a Bosch sensor doesn't it? Quote Link to comment Share on other sites More sharing options...
Tricky-Ricky Posted September 15, 2007 Share Posted September 15, 2007 Can't see the point? Innovate LM-1 is proven to be the best one out there, + it has on board data logging and great software, and its only costs £20 more! Quote Link to comment Share on other sites More sharing options...
Suprash Posted September 15, 2007 Share Posted September 15, 2007 Can't see the point? Innovate LM-1 is proven to be the best one out there, + it has on board data logging and great software, and its only costs £20 more! So this isnt loads cheaper then...... Quote Link to comment Share on other sites More sharing options...
dini_the_owl Posted September 15, 2007 Share Posted September 15, 2007 ive got one and think there very good, tech support is ace too Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.