Guest CoolsBlue Posted July 15, 2007 Share Posted July 15, 2007 hi all, these skirts are bomex and look like theyll fit on nice, but at the bottom there are no fitment holes etc, so was just thinking, to bolt normally from each side end and use about 4 rivets to hold it down just under the door sill, anyone ever done this before?think it will be ok if i do this? Quote Link to comment Share on other sites More sharing options...
Guigsy Posted July 15, 2007 Share Posted July 15, 2007 just put some fitment holes in them with a drill? Quote Link to comment Share on other sites More sharing options...
kieren1234 Posted July 15, 2007 Share Posted July 15, 2007 just put some fitment holes in them with a drill? Yeah that would be the obvious resolution to the problem............ Quote Link to comment Share on other sites More sharing options...
CardiffSupra Posted July 15, 2007 Share Posted July 15, 2007 You should see the 2 tabs on each end of the skirts(underside). Mine did'nt have holes in them either, I didnt want to fix into anything as knowing me Id go straight through the fuel tank. I used Tiger seal on the tabs and screws in the sides, They are stuck solid. Quote Link to comment Share on other sites More sharing options...
Guest CoolsBlue Posted July 15, 2007 Share Posted July 15, 2007 tiger seal aye?tabs aye? what do you mean by tabs? the long part that runs under the sill when you fit the skirts? Quote Link to comment Share on other sites More sharing options...
supra steveo Posted July 15, 2007 Share Posted July 15, 2007 so was just thinking, to bolt normally from each side end and use about 4 rivets to hold it down just under the door sill, anyone ever done this before?think it will be ok if i do this? yeah thats right i stuck three holes along the top of the skirt and screwed in there Quote Link to comment Share on other sites More sharing options...
Guest CoolsBlue Posted July 15, 2007 Share Posted July 15, 2007 looks good in ur garage pics mate, got any close ups of the inner door panel? where the screws are? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.