Pot Posted May 20, 2007 Share Posted May 20, 2007 And I wasn't even using a 14lb lump hammer this time!... (Unlike my spark plugs/warped throttle body incident...)... Anyhow, I've mailed Jody to warn him my car might be into him on Monday (I'm off to Alton Towers on Thursday with a chick with big boobs ), but I was wondering how hard it is to remove the stud, and what kit's needed?... Obviously I'll have to replace the broken stud too, is this just (If I'm lucky) a Halfords job??... I've got a Tap & Die kit, so I'm guessing that and plenty of WD40, a good drill bit to get the stud out, then a replacement stud?... Or should I just spend my Sunday being Hungover, and get it to Jody on Monday?... Will it be OK with 1 O2 sensor being held in with 1 stud for 40 miles on the motorway?... Quote Link to comment Share on other sites More sharing options...
Daston Posted May 20, 2007 Share Posted May 20, 2007 is there any stud left out side of the hole? Quote Link to comment Share on other sites More sharing options...
Pot Posted May 20, 2007 Author Share Posted May 20, 2007 Nah, it's snapped about 1/2mm down... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.