Clutch Kit

How much is a clutch kit for a non-bpu 96 TT 6 speed going to cost me.

Price without flywheel.

How much is a clutch kit for a non-bpu 96 TT 6 speed going to cost me.

 

Price without flywheel.

Available now: Uprated MKIV TT clutches.

I use a stock genuine Toyota, brand new driven plate, as it is correctly

balanced, doesn't judder and will hold all but mega torque

highly modded engines or cars used for drag racing.

I modify a stock brand new Toyota cover to give more clamping force.

The reason I tooled up to do these is some of the aftermarket

US clutches I have fitted SEEM to be built from used cover

assemblies with reground friction surfaces, and a stronger

spring. I have had hellish trouble getting these to fully

release, because due to this seemingly thinner cast iron

friction face, the geometry of the clutch goes to pot, and

being a pull type clutch (the hydraulics pull the bearing

away from the engine, rather than the more normal push type)

it is a lot harder to effect a cure.

For 475 pounds, no VAT to pay, you get a brand new driven

plate, a brand new modded cover, and a brand new release

bearing. I would rather fit myself so any complaints are down

to me, I see too many clutches juddering due to someone without

the right gear allowing the gearbox input shaft to bend the driven

plate. The boxes' weight is allowed to swing on the plate centre, bending it,

or clutches fitted to patently buggered flywheels. However, I might be

persuaded to sell to people using bona fide fitters to install one.

Toyota use a dual mass flywheel (the flywheel is in 2 parts, an inner and

outer assembly, damped in the middle) which is now showing signs

of wear causing a lot of rattle when idling or on very light

throttle openings. For God knows what reason they are charging

about 270 quid for a new one, they look more like they should be

over 500 to me, but don't say anything :-) So if the flywheels

old enough or abused enough to be scored it's best replaced.

If pressed I will sell the clutch kit, which includes a new release

bearing for a 3rd party to fit.

Fitting by myself will cost £175

I used one of these for my NA arrived very fast and had no problems with it what so ever

http://cgi.ebay.com/ebaymotors/TOYOTA-SUPRA-LEXUS-SC300-3-0-L-NEW-OEM-Clutch-Kit_W0QQcmdZViewItemQQcategoryZ33730QQihZ005QQitemZ150121043634QQrdZ1

They do TT ones as well

Well i've just called MR T,

Cover assembly - £146.68 -------31210-14170

Plate - £82.90 -------- 31250-14190

Release Bearing - £51.36 ------- 90903-63001

Flywheel - £294.21 ------- 13450 0W011

Flywheel bolts x 8 - £85.12 ------90910-02115

Hope this helps. All prices exclude VAT and they were going to give me 10% off oh and they will have them in 2 days.

Do you really need to do the bolts??

Thanks for all the info.