supra_si Posted May 9, 2007 Share Posted May 9, 2007 hi ppl, ive seen quite a few cars now and some have mph dials that only go upto 100mph, why is this the case when the car is able to do hell of a lot more. is it an importism?? can it be replaced? Quote Link to comment Share on other sites More sharing options...
edge Posted May 9, 2007 Share Posted May 9, 2007 Its another way of converting without fitting an electronic gadget (speed limiter defender) as the improts are restricted to 112mph (180kph). Better way to do it is fit a sld and just change the the mph on the 180kph dial to mph or you can buy a uk dial for about £15 on fleabay. Quote Link to comment Share on other sites More sharing options...
Guru Posted May 9, 2007 Share Posted May 9, 2007 Not that easy as I found out going from 300mph to a 180mph dial http://www.mkivsupra.net/vbb/showthread.php?t=106497 Quote Link to comment Share on other sites More sharing options...
supra_si Posted May 9, 2007 Author Share Posted May 9, 2007 hmm is this an easy diy job?? Quote Link to comment Share on other sites More sharing options...
Mas Posted May 9, 2007 Share Posted May 9, 2007 Not that easy as I found out going from 300mph to a 180mph dial http://www.mkivsupra.net/vbb/showthread.php?t=106497 Hi mate, only just saw your other thread, I had the same problem when I fitted my very first dial/convertor few years back! Im sure if you have the ignition on when putting the needles back that wont happen Quote Link to comment Share on other sites More sharing options...
Glosphil Posted May 9, 2007 Share Posted May 9, 2007 I fitted a 112MPH dial from ebay. Was a case of lifting the needle over the pin, marking where it sits then removing it and the old dial, stick on the new one, stick on the needle again. I didnt mark where it was so had to fiddle about adjusting it after. If you just turn the ignition on and set it to 0 it is out by 10mph. Bit fiddly but didnt take long. dont want to convert it to MPH with a chip because I want to keep the odo in KM. Quote Link to comment Share on other sites More sharing options...
Guru Posted May 9, 2007 Share Posted May 9, 2007 Hi mate, only just saw your other thread, I had the same problem when I fitted my very first dial/convertor few years back! Im sure if you have the ignition on when putting the needles back that wont happen Mmmm will try that! Thanks Mas Quote Link to comment Share on other sites More sharing options...
Rico2006 Posted May 9, 2007 Share Posted May 9, 2007 dont want to convert it to MPH with a chip because I want to keep the odo in KM. Get the Thor box, it converts the Speedo to MPH but keeps the ODO and Spoiler etc in KMH - excellent little gadget. Quote Link to comment Share on other sites More sharing options...
SatSport Posted May 9, 2007 Share Posted May 9, 2007 the `Yellow Box` is another option.... http://www.blackrobotics.com/yb_home.htm Quote Link to comment Share on other sites More sharing options...
supra_si Posted May 9, 2007 Author Share Posted May 9, 2007 are these boxes expensive?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.