Car Alarm, small advice

[Kev.O]

I'm in the middle of removing my fuel cut controller from the existing ECU wiring. I plan to change the stock alarm at sometime in the future. So do I:
1 - Connect both wires that have been cut into by whoever installed the alarm. (This will also help if I have problems trying to start the car when I get the engine back in)
2 - Leave them and assume the new alarm will use the same wires (I spoke to a car alarm engineer and he said they don't usually cut into the ECU wires usually cut into the ignition)

:search:

[RobSheffield]

I would say 1 Kev :)

[merckx]

I wouldn't necessarily assume your present alarm is wired correctly, it wasn't on mine.

I fitted mine properly. :)

[Kev.O]

Thanks for the quick replies guys. I've soldered them together now. If I need to cut into the ECU wires, I can do it on my fields harness